Rear Wheel Bearing and Hub Replacement DiscBrake

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
3. Inspect the ball joint. Refer to Ball Joint Inspection .
4. Disconnect the sensor lead.
5. If equipped with all-wheel drive (AWD) remove the wheel drive shaft nut. Refer to Rear Wheel Drive Shaft Replacement .



6. Remove the wheel bearing/hub assembly knuckle bolts (1).



7. Remove the wheel bearing/hub assembly (1) from the knuckle (2).

1. Install the wheel bearing/hub assembly (1) on to the knuckle (2).

Notice: Refer to Fastener Notice in the Preface section.




2. Install the bolts (1) into the wheel bearing/hub assembly.

Tighten
Tighten the wheel bearing/hub bolts to 130 N·m (96 lb ft).

3. Install the wheel drive shaft into the wheel bearing and tighten the nut. Refer to Rear Wheel Drive Shaft Replacement .

Tighten
Tighten the nut to 260 N·m (192 lb ft).

4. Connect the sensor lead.
5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
6. Lower the vehicle.