GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2006 🢒 Rendezvous - AWD 🢒 Body 🢒 Wiring Systems 🢒 Instrument Cluster Replacement

Removal Procedure

    Important: Turn the ignition switch to the OFF position before you remove the instrument panel cluster.

  1. Remove the instrument panel (I/P) cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .

    2. Object Number: 771732 Size: SH
  2. Remove the screws from the I/P cluster.
  3. Disconnect the electrical connectors from the I/P cluster.
  4. Remove the I/P cluster.

Installation Procedure
  1. Connect the electrical connectors to the I/P cluster.
  2. Install the I/P cluster.

    3. Object Number: 771732 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the screws to the I/P cluster.

    4. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  4. Install the I/P cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  5. Calibrate the electronic compass. Refer to Electronic Compass Calibration .
  6. Refer to Control Module References for programming and setup information.