GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.


    Object Number: 669311  Size: SH
  1. Disable the SIR. Refer to SIR Disabling and Enabling.
  2. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly.
  3. Remove the fasteners.

  4. Object Number: 669309  Size: SH
  5. Adjust the front seat assembly to the rear of the vehicle.
  6. Angle the front seat cushion (1) up, in order to access the assembly fasteners (2).
  7. Remove the fasteners.
  8. Lift the front seat cushion assembly (1) away from the seat riser.

  9. Object Number: 792019  Size: SH
  10. Disconnect the electrical connector.
  11. Using a flat-bladed tool, release the module from the bracket.
  12. Remove the memory seat module from the seat frame.

Installation Procedure


    Object Number: 792019  Size: SH
  1. Install the memory seat module to the seat frame.
  2. Press the module into the bracket until the module is firmly seated.
  3. Connect the electrical connector to the memory seat module.

  4. Object Number: 669309  Size: SH
  5. Install the seat cushion assembly (1) to the seat riser.
  6. Install the fasteners (2) to the seat cushion assembly (1).

  7. Object Number: 669311  Size: SH
  8. Adjust the front seat assembly up and forward in order to access the fasteners (1).
  9. Notice: Refer to Fastener Notice in the Preface section.

  10. Install the fasteners (1) to the seat cushion assembly.
  11. Tighten
    Tighten the fasteners to 9 N·m (80 lb in).

  12. Angle the front seat cushion up, in order to access the assembly fasteners.
  13. Tighten
    Tighten the fasteners to 9 N·m (80 lb in).

  14. Enable the SIR. Refer to SIR Disabling and Enabling.
  15. Calibrate the seat. Refer to Control Module References for programming and setup information.