GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 326098  Size: SH
  1. Remove the screws from the bottom of the I/P accessory trim plate.
  2. Pull the I/P accessory trim plate rearward in order to release the retaining clips.
  3. Rotate the I/P accessory trim plate rearward and up in order to release the 2 tabs at the top edge.
  4. Disconnect the ash tray harness electrical connector from the I/P harness.
  5. Remove the I/P accessory trim plate.

Installation Procedure

  1. Connect the ash tray harness electrical connector to the I/P harness.

  2. Object Number: 326098  Size: SH
  3. Align the accessory trim plate to the I/P.
  4. Install the tabs into the I/P openings.
  5. Rotate the I/P accessory trim plate forward and press the clips into the retainers until fully seated.
  6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the screws to the I/P accessory trim plate.
  8. Tighten
    Tighten the screws to 2 N·m (18 lb in).