GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P1545: Air Conditioning (A/C) Clutch Relay Control Circuit

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

A/C Relay Coil B+

P1545

P1545

--

--

A/C Compressor Clutch Relay Control

P1545

P1545

P1545

--

Circuit/System Description

The engine control module/powertrain control module (ECM/PCM) controls the A/C compressor clutch based on an A/C request serial data message from the HVAC control module. The ECM/PCM monitors the A/C refrigerant pressure sensor and if pressure is within a specified range, will engage the A/C compressor by grounding the A/C compressor clutch relay control circuit.

B+ is applied to the A/C relay in the RUN/START position and with the A/C compressor clutch relay control circuit grounded by the ECM/PCM, current flows through the coil side of the A/C relay. With current flowing through the coil side of the relay, a magnetic field is created which pulls the switch side of the relay closed, sending current to the A/C compressor clutch, allowing the A/C compressor to be engaged.

Conditions for Running the DTC

An A/C request is received from the HVAC module.

Conditions for Setting the DTC

A short to voltage, short to ground, or open/high resistance is seen on the A/C compressor clutch relay control circuit.

Action Taken When the DTC Sets

DTC P1545 is a Type C DTC

Conditions for Clearing the DTC

DTC P1545 is a Type C DTC

Reference Information

Schematic Reference

HVAC Schematics

Connector End View Reference

HVAC Connector End Views

Description and Operation

Air Temperature Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Scan Tool Output Controls

Circuit/System Verification

Engine running, command the A/C Relay On and OFF with a scan tool. The A/C compressor clutch should engage and disengage.

Circuit/System Testing

  1. Ignition OFF, disconnect the A/C relay.
  2. Ignition ON, verify a test lamp illuminates between the relay coil B+ circuit terminal and ground.
  3. If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. Connect a test lamp between the relay coil B+ circuit terminal and the A/C compressor clutch relay control circuit terminal.
  5. Engine running, command the A/C relay ON and OFF. The test lamp should turn ON and OFF when changing between the commanded states.
  6. If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the ECM/PCM.
    If the test lamp is always OFF< test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM/PCM.
  7. If all circuits test normal, test or replace the A/C relay.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for ECM/PCM replacement, setup, and programming