1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement .



3. If equipped with four-wheel drive, remove the front differential and secure to the frame. Refer to Differential Carrier Assembly Replacement .
4. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement .



5. Remove the transmission oil cooler lines (1) from the retainer (2).



6. Remove the transmission oil cooler line retaining bracket bolt and bracket.
7. Remove the starter. Refer to Starter Motor Replacement .
8. Remove the flywheel inspection cover from the left side of the transmission.



9. Remove the battery cable channel bolt from the front of the oil pan.
10. Remove the battery cable channel from the oil pan.



11. Loosen the 2 upper air conditioning (A/C) compressor bracket bolts (4).
12. Remove the 2 lower A/C compressor bracket bolts (3).



13. Remove the 2 lower bellhousing bolts.



14. Remove the oil pan bolts.
15. Remove the oil pan by tilting the rear of the oil pan down to clear the transmission, pull the oil pan rearward past the front wire harness, then lower the oil pan clear of the vehicle.

Important: 

•	The oil pan gasket is reusable. It is NOT necessary to remove the oil pan gasket unless damaged.

•	DO NOT allow foreign material to enter the oil passages of the oil pan, cap or cover the openings as required.




16. Drill out the oil pan gasket retaining rivets (2), if required.
17. Remove the gasket (1) from the pan.
18. Discard the gasket and rivets.
19. Clean and inspect the oil pan. Refer to Oil Pan Cleaning and Inspection .

Important: 

1. Apply a 5 mm (0.20 in) bead of 20 mm (0.80 in) long to the engine block. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number. Apply the sealant directly onto the tabs of the front cover gasket that protrudes into the oil pan surface.



2. Apply a 5 mm (0.20 in) bead of sealant 20 mm (0.80 in) long to the engine block. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number. Apply the sealant directly onto the tabs of the rear cover gasket that protrudes into the oil pan surface.



3. Pre-assemble the oil pan gasket and bolts to the pan.

•	Install the gasket onto the pan.

•	Install the oil pan bolts to the pan and through the gasket.

4. Install the oil pan, oil pan gasket, and bolts to the engine block as an assembly.
5. Hand thread the oil pan bolts into the engine block until snug. Do not tighten at this time.

Notice: Refer to Fastener Notice in the Preface section.




6. Install the 2 lower bellhousing bolts.

Tighten

1. Tighten the lower bellhousing bolts to 50 N·m (37 lb ft).
2. Tighten the 2 rear oil pan to rear cover bolts to 12 N·m (106 lb in).
3. Tighten the remaining oil pan bolts to 25 N·m (18 lb ft).



7. Install the 2 lower A/C compressor bracket bolts (3).

Tighten
Tighten the bolts to 50 N·m (37 lb ft).

8. Tighten the 2 upper A/C compressor bracket bolts (4).

Tighten
Tighten the bolts to 50 N·m (37 lb ft).




9. Install the battery cable channel to the oil pan.
10. Install the battery cable channel bolt to the oil pan.

Tighten
Tighten the bolt to 12 N·m (106 lb in).

11. Install the flywheel inspection cover to the left side of the transmission.



12. Install the starter. Refer to Starter Motor Replacement .
13. If equipped with four-wheel drive, install the inner axle shaft. Refer to Front Drive Axle Inner Shaft Replacement .
14. Install the transmission oil cooler line retaining bracket and bolt.

Tighten
Tighten the bolt to 9 N·m (80 lb in).




15. Install the transmission oil cooler lines (1) to the retainer (2).
16. Install the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement .
17. Fill the engine with oil. Refer to Engine Oil and Oil Filter Replacement .



18. Install the front differential. Refer to Differential Carrier Assembly Replacement .
19. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .