GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2005 🢒 Rainier 🢒 Body 🢒 Doors 🢒 Door Inside Handle Replacement

Removal Procedure
  1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement or Rear Side Door Trim Panel Replacement .

    2. Object Number: 723027 Size: SH
  2. Remove the handle retaining bolt.
  3. Release the handle locator tab from the locator cutout, by sliding the handle forward.
  4. Release the rod retainer locks.
  5. Remove the rods from the handle.
  6. Remove the handle from the door.

Installation Procedure

    Object Number: 723027 Size: SH
  1. Position the handle to the door.
  2. Install the rods to the handle.
  3. Install the rod retainer locks.
  4. Insert the handle locator tab into the locator cutout and move the handle rearward, indexing the fastener hole to the door.

    5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the handle retaining bolt.

    6. Tighten
    Tighten bolt to 10 N·m (88 lb in).

  6. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement or Rear Side Door Trim Panel Replacement .