The number(s) below refer to the step number(s) on the diagnostic table.
Step | Action | Value(s) | Yes | No | ||||||
---|---|---|---|---|---|---|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Power Door Systems? | -- | Go to Step 2 | |||||||
2 |
Did both outside rearview mirrors move back to the programmed setting? | -- | Go to Step 11 | Go to Step 3 | ||||||
Did the Sensor values change? | -- | Go to Step 8 | Go to Step 4 | |||||||
4 |
Is the voltage indicated within the range given? | 4.5-5.5 V | Go to Step 5 | Go to Step 10 | ||||||
5 |
Is the voltage indicated within the range given? | 4.5-5.5 V | Go to Step 6 | Go to Step 10 | ||||||
6 |
Is the voltage indicated within the range given? | 0-0.5 V | Go to Step 7 | Go to Step 10 | ||||||
7 | Inspect for poor connections at the harness connector of the outside rear view mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 9 | ||||||
8 | Inspect for poor connections at the harness connector of the outside rear view mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 10 | ||||||
9 | Replace the inoperative outside rear view mirror. Refer to Power Window Motor Replacement . Did you complete the replacement? | -- | Go to Step 11 | -- | ||||||
10 | Replace the door module of the inoperative mirror. Refer to Door Control Module Replacement - Front . Did you complete the replacement? | -- | Go to Step 11 | -- | ||||||
11 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |