Arming the CTD System
Use the following procedure in order to arm the system:
- Place the shift lever in P (park).
- Turn OFF the ignition.
- Open any door.
Important: The system is not armed if the doors are locked manually, the power
door lock switch or remote transmitter must be used in order to arm the CTD
system.
- Lock the doors with the power door lock switch or the LOCK button on
the transmitter. The system is in standby mode and will not start the arming
timer until all doors are closed.
- The system will arm approximately 30 seconds from the time that
the last door is closed. This delay is shown by the Security indicator ON
STEADY. When the indicator transitions to OFF, the system is armed.
Locking The Vehicle Without Arming The CTD System
Locking the vehicle may be accomplished without arming the CTD system.
Use of the manual door locks or using the key to lock the LF door will lock
the vehicle, but will not arm the CTD system.
Disarming the CTD System
If system arming has been requested by the power door lock switch or
the transmitter, it must be disarmed.
| Important: Using the power door unlock switch or manually unlocking the doors does
not disable the CTD arm mode. Also, disconnecting the battery or pulling
fuses does not disable the arm mode, since the RFA stores the CTD mode status
in EEPROM.
|
• | In order to disarm the CTD system in standby mode (SECURITY indicator
flashing and door(s) open) perform one of the following procedures: |
- | Press the power door unlock switch. |
- | Use the key in order to unlock the left front door. |
- | Press the UNLOCK button on the transmitter. |
• | In order to disarm the CTD system in delayed mode or armed mode
perform one of the following procedures: |
- | Use the key in order to unlock the left front door. |
- | Press the UNLOCK button on the transmitter. |
Deactivating the CTD System in Alarm Mode
Important: Using the power door unlock switch or manually unlocking the doors does
not disable the CTD alarm mode. Also, disconnecting the battery or pulling
fuses does not disable the alarm mode, since the RFA stores the CTD mode
status in EEPROM.
Use one of the following procedures in order to deactivate and disarm
the CTD system in alarm mode (pulsing horn(s) and exterior lamps flashing):
• | Use the key in order to unlock the LH front door. |
• | Press the UNLOCK button on the transmitter. |
• | Turn ON the ignition with a valid key. |