Schematic
Refer to Theft Deterrent System Schematics
PASS-Key® III
.
Circuit Description
The vehicle theft deterrent (VTD) module checks memory to see if the Learn Coded Key setting is on. If so, the VTD sets this DTC.
Running the DTC
The VTD must see the ignition switch input. The VTD can not have a B1327 set as a current DTC.
Conditions for Setting the DTC
If the Learn Coded Key setting is on, the VTD sets this DTC.
Action Taken When the DTC Sets
The VTD will learn the key code. No driver warning message will be displayed for this DTC.
Conditions for Clearing the MIL/DTC
The VTD clears the current status of the DTC when it does not see the Learn Coded Key setting as on. The DTC will still be retrieved as current until the ignition switch is cycled. The DTC will become a history DTC at that time.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform A Diagnostic System Check - Vehicle Theft Deterrent? | Go to Step 2 | |
|
Important: If a 10 Minute or 30 Minute Re-Learn Procedure is performed, all keys not learned at that time will be erased and will not be recognized. Perform the Quick Learn Procedure on all keys or instruct the customer how to perform the Quick Learn Procedure. Perform the VTD (Pass-Key® III) Module learn Procedure. Refer to Programming Replacement Keys, Ign Cyl, or PCM . Is the procedure complete? | Go to Step 3 | -- | |
3 |
Does the DTC reset? | Go to Step 2 | System OK |
