Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Remote Keyless Entry Diagnostic System Check? | Go to Step 2 | |
2 | Press each button of the transmitter one at a time. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Lock and unlock the door locks using the controls inside the vehicle. Do the locks operate properly? | Go to Step 4 | Go to Symptoms in Doors |
4 | Operate the rear deck release from the controls inside the vehicle. Does the decklid release operate properly? | Go to Step 5 | Go to Symptoms in Body Rear End |
5 |
Important: Inspect that the keyless entry transmitter is the correct model for the vehicle remote system. A wrong model transmitter may pass this test, but will not activate the vehicle remote system.
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 10 | Go to Step 6 |
6 | Do any of the buttons on the transmitter sound the tone and illuminate the green light when pressed? | Go to Step 9 | Go to Step 7 |
7 | Replace the transmitter battery. Refer to Transmitter Battery Replacement . Did you complete the replacement? | Go to Step 8 | -- |
8 |
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 10 | Go to Step 9 |
9 | Replace the transmitter. Refer to Transmitter Replacement . Did you complete the replacement? | Go to Step 13 | -- |
10 | Press the PANIC button on the transmitter. Does the PANIC function operate normally? | Go to Step 11 | Go to Step 13 |
11 | Perform the synchronization procedure. Refer to Transmitter Synchronization . Did the locks cycle to lock then unlock? | Go to Step 12 | Go to Step 13 |
12 | Operate the transmitter within range of the vehicle. Do all of the RFA functions operate normally? | Go to Step 15 | Go to Step 13 |
13 |
Important: All transmitters which are to be recognized by the RFA module must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Perform the programming procedure. Refer to Transmitter Programming . Did the locks cycle to lock then unlock? | Go to Step 15 | Go to Step 14 |
14 | Replace the RFA Module. Refer to RFA Module Replacement . Did you complete the replacement? | Go to Step 15 | -- |
15 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
