Removal Procedure
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.
- Open and lower the instrument panel compartment by carefully releasing
the rear holding tabs.
- Pull down in order to
remove the programmer (1).
- Disconnect the electrical connectors from the programmer.
Installation Procedure
Important: After the programmer is replaced, recalibrate the actuators for proper
travel. Turn ON the ignition for 3 minutes to recalibrate the programmer
and the actuators for proper travel.
- Connect the electrical connectors to the programmer.
- Install the programmer (1)
into the retainer on the bracket (2).
- Close the instrument panel compartment.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.