- Install the ignition and key alarm switch assembly (2) and secure by using the 2 tapping screws (3).
- Push the key alarm connector (1) into the electronic lock module assembly (4).
- Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
- Install the coded key controller (2) onto the electronic lock module assembly (1).
- Connect the connectors (1) and (2) of the ignition and key alarm switch assembly.
- Install the wire harness strap (2) onto the upper tilt head assembly (1).
- Install the 3 wire harness straps (3) onto the wire harness assembly (4).
- Install the wire harness assembly (4) into the wire harness strap (5).
- Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle .
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer Enabling the SIR System to in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 7 N·m (62 lb in).
Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
