For 1990-2009 cars only
- Install the wave washer (1).
- Align the block tooth on the race and upper shaft assembly (1) to the 12 o'clock position.
- A new inflatable restraint steering wheel module coil will be pre-centered. Do not pull off the orange tab in the front of the inflatable restraint steering wheel module coil until installation is complete. Do not depress the service lock tab on the back of the inflatable restraint steering wheel module coil.
- Align the inflatable restraint steering wheel module coil (2) with the horn tower sticking through the shaft lock shield assembly (1).
- Install the inflatable restraint steering wheel module coil onto the upper shaft assembly.
- Install the retaining ring (1).
- Install the black inflatable restraint steering wheel module coil connector (2) to the fused jumper assembly connector (1).
- Install the wire harness assembly (4) into the wire harness strap (5).
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
Important: If you are installing the original coil, center the coil first. Refer to Inflatable Restraint Coil Centering - Off Vehicle .
If a new inflatable restraint steering wheel module coil was installed, remove and dispose of the orange tab.
Important: Seat the retaining ring (1) securely on the groove of the race and the upper shaft assembly (2).
Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
Install the wire harness strap (2) into the steering column tilt head assembly (1).
Install the 3 wire harness straps (3) onto the wire harness assembly (4).
