Removal Procedure
- Disable the SIR system.
Refer to
Disabling the SIR System
in
SIR.
- Remove the steering wheel. Refer to
Steering Wheel Replacement
.
- Remove the steering column shrouds.
- Remove the left closeout/insulator panel (if equipped with traction
control). Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel, Gauges and Console.
- Disconnect electrical connector from traction control harness
if equipped and feed harness out of column. Observe the harness routing and
location to assist in reassembly.
- Remove the TORX® head fastener from the shift lever to shift
control.
- Pull the shift lever upward to remove it from the shift control.
Installation Procedure
- Push the shift lever downward
to engage it into the shift control.
- Install the TORX® head fastener.
- Feed the traction control harness (if equipped) back throught
the column. Use care to route the harness as previously observed.
- Install the steering column shrouds.
- Install the steering wheel. Refer to
Steering Wheel Replacement
.
- Install the left closeout/insulator panel (if equipped with traction
control). Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel, Gauges and Console.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.