Generator Replacement VIN 1

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
3. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.



4. Remove the generator brace.
5. Remove the output terminal nut.
6. Disconnect the electrical connector.



7. Remove the generator mounting bolts.
8. Remove the generator.

1. Position the generator on the engine.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the generator mounting bolts

Tighten
Tighten the bolts to 50 N·m (37 lb ft).

3. Connect the electrical connector.
4. Install the output terminal nut.

Tighten
Tighten the nut to 20 N·m (15 lb ft).




5. Install the generator brace and fasteners.

Tighten

•	Tighten the nut to 50 N·m (37 lb ft).

•	Tighten the bolt to 25 N·m (18 lb ft).

6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.
7. Install the drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

Generator Replacement VIN K

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
3. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.



4. Remove the generator brace.
5. Remove the output terminal nut.
6. Disconnect the electrical connector.



7. Remove the generator mounting bolts.
8. Remove the generator.

1. Position the generator on the engine.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the generator mounting bolts

Tighten
Tighten the bolts to 50 N·m (37 lb ft).

3. Connect the electrical connector.
4. Install the output terminal nut.

Tighten
Tighten the nut to 20 N·m (15 lb ft).




5. Install the generator brace and fasteners.

Tighten

•	Tighten the nut to 50 N·m (37 lb ft).

•	Tighten the bolt to 25 N·m (18 lb ft).

6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.
7. Install the drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .