Important: Care must be taken when handling engine coolant temperature sensor. Damage to the engine coolant temperature sensor will affect proper operation of the Fuel Injection System.

1. Drain the radiator coolant.
2. Disconnect the ECT sensor electrical connector.



3. Using a 19 mm deep well socket and an extension remove the ECT sensor.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: Care must be taken when handling engine coolant temperature sensor. Damage to the engine coolant temperature sensor will affect proper operation of the Fuel Injection System.

1. Hand start the ECT sensor into the engine.

Tighten
Tighten the ECT sensor to 30 N·m (22 lb ft).

2. Connect the electrical connector.
3. Refill the radiator with coolant.
4. Start the engine and check for leaks.
5. Check the coolant level.