GM Service Manual Online
For 1990-2009 cars only

    Object Number: 262991  Size: SH
  1. Remove the key from the ignition switch.
  2. Connect the passenger side air bag yellow connector (1) to vehicle harness yellow connector (4) located under the passenger seat.
  3. Install the Connector Position Assurance (CPA) to the passenger side air bag yellow connector (4).
  4. Connect the driver side air bag yellow connector (1) to vehicle harness yellow connector (4) located under the driver seat.
  5. Install the Connector Position Assurance (CPA) to the driver side air bag yellow connector (4).

  6. Object Number: 464940  Size: SH
  7. Connect the passenger (IP) frontal air bag yellow connector (2) to the vehicle harness yellow connector (1) located above the passenger sound insulator.
  8. Install the Connector Position Assurance (CPA) (4) to the passenger yellow connector (1).
  9. Install the passenger sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages and Console.

  10. Object Number: 464953  Size: SH
  11. Connect the driver frontal air bag yellow connector (4) to the vehicle harness yellow connector (3) located next to steering column (2).
  12. Install the Connector Position Assurance (CPA) (1) to the driver yellow connector (3).
  13. Install the driver sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.

  14. Object Number: 465618  Size: SH
  15. Install the SIR fuse to the rear fuse block.
  16. Rear fuse block is located under the rear seat.

  17. Install the rear seat. Refer to Rear Seat Cushion Replacement .
  18. Important: Stay well away from all air bags.

  19. Turn the ignition switch to the ON position.
  20. 14.1. The AIR BAG warning lamp will flash 7 times.
    14.2. The AIR BAG warning lamp will then turn OFF.
  21. Perform the SIR Diagnostic System Check if the AIR BAG warning lamp does not operate as described. Refer to Diagnostic System Check - SIR .