Special Tools

J 38778 Door Trim Pad and Garnish Clip Remover

1. Remove the rear seat back. Refer to Rear Seat Back Replacement.
2. Remove the door weatherstrip from the pinch weld flange to expose the upper quarter trim panel.
3. Remove the screw cover and screw in the top of the panel (1).
4. Use J 38778 to disengage the push-in retainers and remove the trim panel.

1. Position the upper quarter trim panel into place.
2. Install the push-in retainers to secure the trim panel (1).

Caution: Refer to Fastener Caution in the Preface section.

3. Install the quarter upper panel screw in the top of the panel.

Tighten
Tighten the quarter upper panel screw to 3 N·m (27 lb in).

4. Install the door weatherstrip onto the pinch weld flange.
5. Install the rear seat back. Refer to Rear Seat Back Replacement.