Special Tools

1. Remove the left bank ignition coils. Refer to Ignition Coil Replacement.
2. Install J 42451-1 bracket, using M10 bolts onto the left front of engine.
3. Install the J 28467-501  (1, 7) onto fender rails near the strut towers.
4. Install the J 28467-3 cross car tube (2) to the J 28467-501  (1, 7).
5. Install the J 28467-2A radiator shelf tube on top of the J 28467-3 cross car tube (2).
6. Install the round tube of the J 28467-4A front support assembly  (4) through the large hole in the J 28467-2A radiator shelf tube. The hole used in the J 28467-2A radiator shelf tube (5) depends on the vehicle application.
7. Place the rubber padded foot of the J 28467-4A front support assembly on the upper tie bar.
8. Install the J 28467-9  7/16-inch x 2.0-inch quick release pin through the hole in the J 28467-4A front support assembly in order to level the J 28467-2A radiator shelf tube.
9. Install the J 28467-7A lift hook through the J 28467-6A lift hook bracket (5).
10. Install the J 28467-6A assembled lift hook bracket (6) over the J 28467-3 strut tower tube (2).