Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B0934: Compass Sensor Circuit HighDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Ignition 1 Voltage | -- | B0935 | -- | B0931 |
Compass Sensor Feed | B0933 | B0935 | B0934 | B0931 |
Compass Sensor Return | B0933 | B0935 | B0934 | B0931 |
Compass Ground | -- | B0935 | -- | B0931 |
Circuit Description
The internal fault detection of the electronic compass module is handled by the instrument panel cluster (IPC). The compass information is sent to the IPC via 2 discreet wire inputs from the electronic compass module. The IPC displays compass information in the driver information center (DIC).
Conditions for Running the DTC
The instrument panel cluster (IPC) monitors the analog input value once every ignition cycle at power up.
Conditions for Setting the DTC
The IPC detects that either compass input circuit(s) is shorted to battery.
Action Taken When the DTC Sets
The DTC will be set and stored in non-volatile memory.
Conditions for Clearing the DTC
| • | The DTC will become history when a power cycle has been performed and the fault is not detected by the IPC. |
| • | A history DTC will clear after 100 fault-free ignition cycles. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Driver Information Center (DIC) Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the electronic compass module.
- Ignition OFF, test for less than 1 ohm between the ground circuit terminal 14 and ground.
- Ignition ON, verify that a test lamp does not illuminate when connected between the compass sensor feed terminal 12 and the ground circuit terminal 14.
- Ignition ON, verify that a test lamp does not illuminate when connected between the compass sensor return terminal 11 and the ground circuit terminal 14.
- If all circuits test normal, test or replace the electronic compass module.
| ⇒ | If greater than the specified value, test the ground circuit for an open/high resistance. |
| ⇒ | Ignition ON, verify that a test lamp illuminates when connected between the ignition voltage circuit terminal 13 and the ground circuit terminal 14. |
| ⇒ | If the test lamp does not illuminate, test the ignition voltage circuit for a short to ground or an open/high resistance. |
| ⇒ | If the test lamp illuminates, test the compass sensor feed terminal 12 for a short to voltage. |
| ⇒ | If the test lamp illuminates, test the compass sensor return terminal 11 for a short to voltage. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for the electronic compass module replacement, setup and programming |
