GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Refer to Heated Oxygen and Oxygen Sensor Caution in the Preface section.


    Object Number: 1858010  Size: SH
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
  2. Disconnect the engine wiring harness electrical connector (2) from the heated oxygen sensor (HO2S) electrical connector (3).
  3. Remove the HO2S electrical connector retainer from the engine wiring harness clip (1).

  4. Object Number: 1858130  Size: SH
  5. Remove the HO2S (1) from the exhaust manifold.

Installation Procedure

Note: A special anti-seize compound is used in the HO2S threads. The compound consists of liquid graphite and glass beads. The graphite tends to burn away, but the glass beads remain, making the sensor easier to remove. New, or service replacement sensors already have the compound applied to the threads. If the sensor is removed from an exhaust component and if for any reason the sensor is to reinstalled, the threads must have anti-seize compound applied before the reinstallation.


    Object Number: 1858130  Size: SH
  1. If reinstalling the old sensor, coat the threads with anti-seize compound GM P/N 12377953, or equivalent.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the HO2S (1) to the exhaust manifold.
  4. Tighten
    Tighten the sensor to 42 N·m (31 lb ft).


    Object Number: 1858010  Size: SH
  5. Connect the engine wiring harness electrical connector (2) to the HO2S electrical connector (3).
  6. Install the HO2S electrical connector retainer to the engine wiring harness clip (1).
  7. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.