Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1480 00: Battery Rundown Protection CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Courtesy Lamp High Control | B1480 00 | 1, 2, 3, 4 | -- | -- |
Ground | -- | 1, 2, 3, 4 | -- | -- |
1. I/P Compartment Lamp Inoperative 2. Courtesy/Reading Lamps Inoperative 3. Cargo Lamp Inoperative 4. Vanity Mirror Lamps Inoperative | ||||
Circuit/System Description
Battery voltage is applied at all times to the body control module (BCM) from the INT LAMPS Fuse located in the rear fuse block. The BCM then applies this voltage to the following lamps:
| • | I/P compartment lamp |
| • | Courtesy/reading lamps |
| • | Cargo lamp |
| • | Vanity mirror lamps |
In the event that any of these lamps were to remain illuminated for more the 20 minutes with the ignition switch in the OFF position, the BCM will deactivate the inadvertent power courtesy lamps circuit to prevent total battery discharge.
Conditions for Running the DTC
Battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
The BCM detects a short ground on the inadvertent power courtesy lamp circuit.
Action Taken When the DTC Sets
The BCM will deactivate the inadvertent voltage to the courtesy lamps.
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | A history DTC will clear once the 100 consecutive malfunction free ignition cycles have occurred. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Interior Lighting Systems Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Testing
- Ignition OFF, disconnect the appropriate harness connector at each component fed by the courtesy lamp high control circuit.
- Ignition ON, with a scan tool clear the DTC.
- Operate the system within the Conditions for Running the DTC and verify the DTC does not reset.
- Connect each component one at a time and verify that the DTC does not reset.
| ⇒ | If the DTC resets, test the courtesy lamp high control circuit for a short to ground. If the circuit tests normal, replace the BCM. |
| ⇒ | If the DTC resets, test or replace the component responsible for setting the DTC. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for BCM replacement, setup, and programming |
