Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0297 00: Brake Applied Output CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Brake Signal | C0297 00 | -- | -- | -- |
Circuit/System Description
The body control module (BCM) provides a 5-volt reference voltage and a low reference signal to the brake pedal position sensor (BPPS). When the brake pedal is applied, the BPPS sends a variable voltage signal, that will increase as the brake pedal is applied, through the stop lamp switch signal circuit to the BCM. The BCM then applies a signal through the stop lamp switch signal circuit to the engine control module (ECM) and transmission control module (TCM).
Conditions for Running the DTC
| • | The engine must be ON. |
| • | The brake must be applied. |
Conditions for Setting the DTC
The BCM detects a short to ground in the stop lamp switch signal circuit.
Action Taken When the DTC Sets
| • | The BCM stores the DTC to memory. |
| • | The Service Vehicle Soon indicator is commanded ON. |
Conditions for Clearing the DTC
A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Exterior Lighting Systems Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Ignition ON, press and release the brake pedal. The stop lamps should illuminate then go out.
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the TCM and the X1 harness connector at the ECM.
- Connect a test lamp between the TCM signal circuit terminal 16 and ground.
- Ignition ON, press and release the brake pedal. The test lamp should turn ON and OFF when pressing and releasing the brake pedal.
- Ignition OFF, connect the harness connector at the TCM.
- Connect a test lamp between the ECM signal circuit terminal 7 and ground.
- Ignition ON, press and release the brake pedal. The test lamp should turn ON and OFF when pressing and releasing the brake pedal.
- If all circuit tests normal, replace the ECM.
| ⇒ | If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit test normal, replace the BCM. |
| ⇒ | If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the BCM. |
| ⇒ | If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the TCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for BCM, ECM, and TCM replacement, setup, and programming
