GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2008 🢒 Enclave 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Removal Procedure

    Object Number: 1860429 Size: SH
  1. Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.
  2. Disconnect the engine wiring harness electrical connector (3) from the bank 2 exhaust camshaft position (CMP) sensor (4).

    3. Object Number: 1860459 Size: SH
  3. Remove the CMP sensor bolt and sensor (4).

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1860459 Size: SH
  1. Install the CMP sensor (4) and bolt.

    2. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1860429 Size: SH
  2. Connect the engine wiring harness electrical connector (3) to the bank 2 exhaust CMP sensor (4).
  3. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.