Tools Required

J 39400-A Halogen Leak Detector

1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.1L.



2. Disconnect the A/C refrigerant pressure sensor from the electrical connector.



3. Remove the A/C refrigerant pressure sensor from the condenser tube.

1. Install the new O-ring seal. Refer to O-Ring Replacement .




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the A/C refrigerant pressure sensor to the condenser tube.

Tighten
Tighten the sensor to 4.7 N·m (41 lb in).




3. Connect the A/C refrigerant pressure sensor to the electrical connector.
4. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.1L.
5. Leak test the fittings of the component using J 39400-A .