Removal Procedure
- Remove the cruise control cable from the cruise control module. Refer to Cruise Control Cable Replacement.
- Disconnect the electrical connector from the cruise control module.
- Remove the cruise control module retaining nuts from the shock tower.
Important: The cruise control module is mounted to the left strut tower. Service the cruise control module as a complete unit.
Installation Procedure
- Install the cruise control module on the shock tower mounting studs.
- Install the cruise control module retaining nuts.
- Connect the electrical connector to the cruise control module.
- Install the cruise control cable to the cruise control module. Refer to Cruise Control Cable Replacement.
- Refer to Control Module References for programming and setup information.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the cruise control module to shock tower nuts to 2 N·m (18 lb in).
