Circuit Description
The battery feed circuit, from the DOOR LOCKS fuse to the BCM, provides power for the door locks.
Conditions for Running the DTC
| • | The BCM must be powered. |
| • | The voltage on the battery feed circuit, from the DOOR LOCKS fuse to the BCM must be between 9-16 volts. |
Conditions for Setting the DTC
The BCM detects that the circuit from the DOOR LOCKS fuse to the BCM is less than 1 volt for 300 milliseconds.
Action Taken When the DTC Sets
The BCM stores DTC B1334 in memory.
Conditions for Clearing the DTC
| • | A current DTC B1334 will clear if the BCM no longer detects the fault. |
| • | A history DTC B1334 will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present. |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Body Control System Schematics | |||
1 | Perform the diagnostic system check for the system that exhibits symptoms. Refer to Control Module References . Did you perform the Diagnostic System Check? | Go to Step 2 | |
2 |
Does the scan tool display Present? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Test the battery circuit that does not display Present in the previous step for an open, high resistance, or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 6 | Go to Step 4 |
4 | Inspect for poor connections at the harness connector of the Body Control Module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 6 | Go to Step 5 |
5 |
Important: Set up new Body Control Module. Refer to Body Control Module (BCM) Programming/RPO Configuration . Replace the Body Control Module. Refer to Body Control Module Replacement . Did you complete the repair? | Go to Step 6 | -- |
6 |
Does the DTC reset? | Go to Step 2 | System OK |
