GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2001 🢒 Century 🢒 Body and Accessories 🢒 Seats 🢒 Power Seat Riser Trim Cover Replacement

Removal Procedure
  1. Use a flat-bladed tool in order to carefully release the retainer from the base of the recliner handle.
  2. Remove the recliner handle.

    3. Object Number: 310416 Size: SH
  3. Remove the finish panel screws.
  4. Pull the finish panel away from the seat cushion frame in order to release the clips.

    5. Discard the clips.

  5. Disconnect the power seat switch electrical connector, if equipped.
  6. Remove the finish panel from the seat.

Installation Procedure

    Object Number: 310416 Size: SH
  1. Install the finish panel to the seat.
  2. Connect the power seat switch electrical connector, if equipped.
  3. Use new clips in order to snap the finish panel to the seat cushion frame.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the finish panel screws.

    5. Tighten
    Tighten the finish panel screws to 3 N·m (27 lb in).

  5. Install the retainer to the base of the recliner handle.
  6. Install the recliner handle.