Schematic Reference: Exterior Lights Schematics

Connector End View Reference: Master Electrical Component List

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

Place the hazard switch to the ON position.

Do the hazard lamps turn ON?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

1. Disconnect the driver information center (DIC)/hazard switch.
2. Install a fused jumper between the hazard switch signal circuit and the ground circuit.

Do the hazard lamps illuminate?

Go to Step 8

Go to Step 4

Using a test lamp connected to battery positive voltage, probe the ground circuit of the hazard switch.

Does the test lamp illuminate?

Go to Step 5

Go to Step 6

Test the hazard warning switch signal circuit for an open, a poor connection, or a short to battery positive voltage . Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 7

Repair a poor connection, an open, or a short to battery positive voltage in the hazard warning switch ground circuit. Refer to Circuit Testing and Wiring Repairs .

Did you complete the repair?

Go to Step 9

--

Replace the body control module (BCM). Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 9

--

Replace the DIC/hazard switch. Refer to Driver Information Display Switch Replacement .

Is the repair complete?

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3