Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Place the hazard switch in the OFF position. Do the hazard lamp remain ON continuously? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
3 | Disconnect the driver information center (DIC). Do the hazard lamps turn OFF? | Go to Step 6 | Go to Step 4 |
4 | Test for a short to ground in the hazard switch signal circuit. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 7 | Go to Step 5 |
5 | Replace the body control module (BCM). Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 7 | -- |
6 | Replace the DIC. Refer to Control Module References for replacement, setup, and programming. Did you complete the repair? | Go to Step 7 | -- |
7 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
